GO2 Dentagenie Sonic Cleaner 2GO

Usage instructions

1. Open the cover and add the appliance to be cleaned into the unit (do not turn the unit on).

2. Please add water to the cleaning tank without exceeding the ‘MAX’ water level.

3. Base unit: to turn on, please press the switch button for 1.5 seconds to start the unit. The green light will show and the unit will operate for 3 minutes. Machine will automatically stop at end of 3 minutes.

4. Should you wish for longer intermittent cleaning, once machine is working, press the switch button again to change to the blue light. This indicates that the machine is now in intermittent mode and will operate for 5 minutes, stopping every 5 seconds and starting again.

5. Whether in 3 min or 5 min mode, to turn off the machine while it’s working, long press the switch button for 1.5 seconds to turn machine off or machine will automatically stop at the end of the 3 or 5 minute modes.

6. UV Lid unit: press the lid button for 1.5 seconds. The UV sterilisation lamp will activate. It will automatically turn off after 5 minutes if you do not turn it off at same time as the base unit.

7. At the end of the base cleaning mode, open the lid, remove the sterilised item and pour water out. Wipe GO2 Sonic 2GO with a clean dry cloth or paper towel to ensure it is dry.

After Use Instructions

1. Empty the tank, rinse with clean water and dry. Leave lid off to ensure all water evaporates.

2. If you find the unit needs more thorough cleaning over time, add half the recommended amount of water to the cleaning tank, wash with a soft sponge and then rinse with clean water. If the stain is more serious, drop 1-2 drops of a neutral detergent into the water and repeat.

3. To clean the outer surface of the unit, wipe with a damp cloth and dry.

4. It is important to note that when emptying water from the unit, please pour from the side to avoid water coming into contact with electric components. Water on these areas will cause failure and damage. Charging instructions To charge both base and lid units, open plastic cover protecting the charging openings. Insert charging cable and attach to power outlet. Red light will pulse while charging. Remove charging cable, ensure plastic cover is secure over the charging inlet once charging complete.

Storage and Disposal Instructions: Keep away from direct contact of electrical input and water.

Safety Warnings & Precautions Safety precautions must be strictly observed and implemented. - Do not allow children to use without adult supervision. Keep out of reach of children at all other times. - If you have an internal pacemaker, it is recommended not to use this product. A sense of discomfort may be experienced. - You must add water first before turning on the machine. - Do not allow the water in the tank to drop below 2.5cm from bottom of tank. - Do not run empty or over the MAX water level line. - Avoid getting water inside the housing or on electric components. Recommend pouring out water from the side. - Do not use liquid bleach in the tank or denture tablets that may foam and spill over the top. - Do not use hot water in the appliance. Hot water may damage dental appliances and will cause the unit to overheat. - Do not put corrosive, flammable, or ammoniated liquids in the tank as they may ignite and/or cause injury. - Do not use the tank to soak appliances with chemical solutions overnight or for an extended time. - Do not look directly into the UV light. - Keep away from children or people without proper ability to hand the unit responsibly. - Do not disassemble, repair, or modify the unit. - Do not Use products other than special adapters. could cause fire, electric shock. - Do not touch the Power Plug with wet hands, especially when inserting or removing the plug. could cause fire, electric shock and malfunction. - Remove the Power Plug from the socket if the device is not going to be used For a Long time. Easy to cause fire, electric shock and malfunction.

Care Instructions

Pour water into the tank, half way to the MAX level. After washing with a soft sponge, rinse with the cleaning water. 2. Be careful not to seep water into the power connection at bottom of the cleaning tank. 3. After cleaning, please rinse items with clean water once again. *Don't seep water into the power connection when cleaning. 4. When the stains are difficult to remove, please wet a clean cloth with water, then wipe them. *Be careful not to seep water into the switch and power connections. 5. After wiping, dry the device with a dry cloth.